10
3.
If the chain requires adjusting, loosen the axle with a 22mm wrench, and loosen
the jam nut with an 11mm wrench. Tighten the chain by rotating the adjustor
bolts clockwise (CW) or loosen the chain by rotating the adjustor bolts (CCW).
4.
Put a rag between the sprocket and
chain, and roll the wheel backward
to pull the chain adjustor blocks
tightly against the adjustor bolts
(Figure 3).
5. Retighten the axle bolt to 25 ft-lb (34
Nm).
6. Retighten the adjustor jam nuts.
CAUTION:
Always check rear brake adjustment
and free-play after adjusting the chain.
Air Filter Cleaning
Tools recommended for air filter maintenance:
5 mm hex key (Allen)
Foam
filter
oil
Procedure
1. Removed seat with the 5mm hex key.
2. Unhook the air filter wire from its perch
3. Carefully remove the air filter and frame out the
top of the airbox making sure not to dislodge
any dirt into the intake tract.
4. Clean the filter in a nonflammable solvent to
remove the filter oil.
Do not clean the air filter with gasoline or other
highly volatile petroleum product. Diesel fuel, mineral
spirits, or kerosene would be preferred but caution
should still be taken.
5. Clean the filter in hot soapy water to remove all
dirt particles.
6. Allow it to dry thoroughly.
7. Saturate with filter oil and remove excess.
NOTE:
It is very important to keep the air filter clean
and properly oiled with high quality water-resistant
foam filter oil. Apply oil consistently because varied
amounts of oil will affect carburetor jetting.
Figure 5
Figure 4
Figure 3