Cobra CX50 JR 2015, Руководство пользователя

Страница: 45 / 79

3. Hold the throttle wide open, and kick repeatedly (approximately 20 times)
or until the gauge reading does not increase in value with each kick.
Base Gasket Selection
Tools required
•
17mm wrench
•
1mm flexible solder material
•
measurement calipers
When rebuilding the ‘top end’ of your Cobra motorcycle, care must be taken to
ensure the proper squish clearance. Squish clearance is defined as the minimum
distance between cylinder head and piston at TDC. There are
either having too much or too little clearance. Since parts like the crank,
connecting rod, cylinder head, piston, and crankcases all have varying
tolerances, Cobra offers several different base gasket thickness’ to ensure that
you can always set the squish clearance of your engine to factory specifications.
For base gasket replacement use the code (see figure 31 for location) along with
the table below to reorder the correct thickness gasket.
Figure 31
Code
Supplied Base
Gasket Thi
# mm
3 0.3
4 0.4
5 0.5
6 0.6
7 0.7
8 0.8
NOTE: Tolerances will affect the actual gasket thicknesses.
45
Hold the throttle wide open, and kick repeatedly (approximately 20 times)
or until the gauge reading does not increase in value with each kick.
Base Gasket Selection
solder material
When rebuilding the ‘top end’ of your Cobra motorcycle, care must be taken to
ensure the proper squish clearance. Squish clearance is defined as the minimum
distance between cylinder head and piston at TDC. There are negative effects of
either having too much or too little clearance. Since parts like the crank,
connecting rod, cylinder head, piston, and crankcases all have varying
tolerances, Cobra offers several different base gasket thickness’ to ensure that
always set the squish clearance of your engine to factory specifications.
For base gasket replacement use the code (see figure 31 for location) along with
the table below to reorder the correct thickness gasket.
Supplied Base
Gasket Thickness
Cobra #
mm inch Part #
0.012 ZCMU0703
0.015 ZCKG0501
0.020 ZCMU0705
0.024 ZCMU0706
0.028 ZCMU0707
0.031 ZCMU0708
Tolerances will affect the actual gasket thicknesses.
Hold the throttle wide open, and kick repeatedly (approximately 20 times)
or until the gauge reading does not increase in value with each kick.
When rebuilding the ‘top end’ of your Cobra motorcycle, care must be taken to
ensure the proper squish clearance. Squish clearance is defined as the minimum
negative effects of
either having too much or too little clearance. Since parts like the crank,
connecting rod, cylinder head, piston, and crankcases all have varying
tolerances, Cobra offers several different base gasket thickness’ to ensure that
always set the squish clearance of your engine to factory specifications.
For base gasket replacement use the code (see figure 31 for location) along with