3
Operation
©
Moffat Ltd, September 2008
7
Revision 1
Cobra Series CT6 Gas Griddle Toaster
NOTE: A full user’s operation manual is supplied with the product and can be used for further
referencing of installation, operation and service.
3.1
Description of Controls
Piezo Igniter
Gas Control Knobs
OFF
Position
PILOT Burner
HIGH Flame
LOW Flame
Piezo Igniters
Ignites the Pilot Burners.
Lighting the Pilot Burners
1.
Depress the gas control knob and rotate
anti-clockwise to the ‘PILOT’ position.
2.
With the control knob depressed, press the
piezo ignition button on the front control
panel adjacent to the gas control knob until
the pilot burner ignites. Pilot ignition can be
viewed through openings in the control
panel.
3.
Hold in the gas control knob for
approximately 10 seconds, then release.
The pilot burner should remain alight. If not
repeat Items 1 to 3.
4.
Repeat Items 1 to 3 to light the second pilot
burner.
5.
‘FULL’ flame can now be achieved by
rotating the gas control knob anti-clockwise
to the first stop.
6.
‘LOW’ flame can be achieved by depressing
and rotating the gas control knob fully anti-
clockwise.
Using the Griddle
1.
Light the pilot burners as shown opposite.
2.
Turn the gas controls to the ‘FULL’ flame
position and allow the griddle plate to
preheat for 10 minutes if starting from a
cold start.
3.
Place the product to be cooked onto the
griddle plate.
4.
For intermediate heat, position the gas
control knob between the ‘HIGH’ and ‘LOW’
positions to achieve the desired heat.
5.
During idle periods, the burners can be
turned down to maintain an appropriate
griddle plate temperature or the gas controls
can be set to the ‘PILOT’ position as
required.
Figure 3.1a