To charge a 5V USB device, connect the devices’ cable to the JumPack’s
USB output. The JumPACK will turn on, and start charging the device
automatically. The blue LEDs will indicate that the device is charging.
Press the Power/Flashlight/Battery capacity button for 3 seconds to turn
S.O.S. and Off.
Battery Status Indicator LEDs
Note:
When charging a device the number of lit LEDs may decrease
while the JumPack is in use. The battery capacity indicator cannot
the real battery capacity, disconnect the device being charged and
1
LED on: 10%-40% charge
2
LEDs on: 40%-65% charge
3
LEDs on: 65%-85% charge
4 LEDs on: 85%-100% charge
To check the battery capacity of the JumPack press the
Power/Flashlight button on the top of the unit with no device
connected. The blue LEDs will show the remaining battery
capacity:
Check Battery Capacity:
.7.
.6.
LED Flashlight:
Charging a 5V USB Device:
1.
Make sure the JumPack is fully charged.
2.
Turn off all the accessories on the vehicle.
3.
Disconnect the battery cables from the JumPack.
4.
Connect the RED clamp to the POSITIVE post of the battery.
5.
Connect the BLACK clamp to the NEGATIVE post of the battery.
6.
Connect the battery cables into the JumPack cables port/jack. Be
7.
Turn the ignition key to start the vehicle for
3 seconds
only. If the
engine starts;
8.
Disconnect the cables from the battery from the JumPack then
from the battery posts.
9.
Leave the engine running for a few minutes before turning the
ignition off.
10.
wait for 1 minute
before trying to start the vehicle again.
Starting a Vehicle:
.5.
.4.
START
Product Features:
•
7500 mAh Lithium Cobalt rechargeable battery.
•
200 Amp Starting Current/400 Amp Peak Current.
•
5V/2.1 Amp USB Output for rapid charging of portable devices.
•
High Intensity work/Strobe/S.O.S LED light.
•
Rechargeable by 240 V AC wall adapter or 13.8 V DC car adapter.
•
Li-Cobalt rechargeable battery: 3.7 V/7500 mAh
•
Size:
5.03” x 2.87” x 0.98”
(128 mm x 73 mm x 25 mm)
•
Weight:
10.58 oz. (300 g.)
•
Recharge time:
3 hours
•
Starting/Peak Current:
200 Amps/400 Amps
•
USB Output:
2.1 Amps
CUSTOMER SUPPORT & TRADEMARKS
Customer Support
Should there be any problems with this product or further information
needed on its features please visit www.cobra.com for support, frequently
asked questions, Declarations of Conformity, and the electronic manual.
For warranty and customer service information please contact the seller.
WEEE
For European Community Users
Cobra Electronics Corporation complies with Directive 2012/19/EU OF
THE EUROPEAN PARLIAMENT AND OF THE COUNCIL 4 JULY 2012 on
waste electrical and electronic equipment (WEEE).
Waste Electrical and Electronic Equipment Information
This product has required the extraction and use of natural resources for
its production. It may contain hazardous substances that could impact
health and the environment, if not properly disposed. In order to avoid
the dissemination of those substances in our environment and to
diminish the pressure on the natural resources, we encourage you to use
the appropriate take-back systems for product disposal. Those systems
will reuse or recycle most of the materials of the product you are disposing
in a sound way.
The crossed out wheeled bin symbol informs you that the product
should not be disposed of along with municipal waste and invites you
to use the appropriate separate take-back systems for product disposal.
If you need more information on the collection, reuse and recycling
systems, please contact your local or regional waste administration.
You may also contact your supplier for more information on the
environmental performances of this product.
Trademark Statement
©2014 Cobra Electronics Corporation, 6500 West Cortland Street,
Chicago, Illinois 60707 U.S.A.
Cobra, the snake design is a proprietary trademark of Cobra Electronics
Corporation, USA.
CPP7500E_MANL_ENG.indd 2
7/3/14 12:10 PM
CPP7500E_MANL_ENG.pdf 1 7/3/14 12:18 PM
