®
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180 Fax. 714.692.5016
www.cobrausa-hd.com
04/17
®
Instruction Manual >
602-2004/602-2004B
Page 2 of 4
6.
Install the right mounting bracket between the fender rail and fender (part # facing inward). The boss
on the front of the nut plate will insert through the large hole on the front of the mount bracket. The
rear of the mount bracket is slotted to slide over the rear turn signal bolt and over the turn signal
wiring. See
FIGURE 2.
7.
Align the front boss on the nut plate with the front hole of the mounting bracket and push the nut plate
outward to seat it against the inner fender and into the frame rail. See
FIGURE 2.
8.
Insert the 3/8-
16 x 2” button head bolt through the supplied front mounting bushing, through the front
frame rail hole, through the mount bracket and into the inner nut plate. Snug the bolt making sure the
front boss of the nut plate inserts through the hole in the mount bracket and into the frame rail. DO
NOT TIGHTEN front bolt at this time. See
FIGURE 3.
9.
Push down on the rear of the mount bracket to make sure it is aligned with the rear turn signal bolt
and tighten the bolt. Make sure the turn signal wire is going through the clearance hole in the mount
bracket and is not getting pinched. See
FIGURE 3.
10.
Tighten the front bolt securing the front mounting bushing.
11.
Repeat Steps 2
–10 on the left side.
DOCUMENT NO. 0018
REV. A
FIGURE 3
MAKE SURE NOT TO
PINCH TURNSIGNAL
WIRES
FRONT MOUNT
BUSHING
3/8-
16 X 2”
BUTTONHEAD
BOLT
FIGURE 2
SLOT FOR TURN
SIGNAL BOLT
SLOT FOR TURN
SIGNAL WIRES
ALIGN FRONT HOLE
OF BRACKET WITH
FRONT HOLE OF
FRAME RAIL
RIGHT SIDE
MOUNT BRACKET
CONTINUED ON PAGE 3
