23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180 Fax. 714.692.5016
www.cobrausa.com
07/09
2
Instruction Manual >
4718 – 4818 – 4918
Page 2 of 2
10. Install one billet tip on each heatshield making sure the ends of the tips are parallel with each other.
On Slashdown models, make sure the angled ends of the tips are parallel with each other. Fasten the
tips with the supplied ¼” x 20 buttonhead screws making sure they snug up against the heatshield
leaving no gap between the tip and heatshield when tightened.
If it is difficult to slide the tips into
the heatshields loosen the clamps on the heatshield and adjust until aligned, avoiding this may
cause damage to the chrome tips
.
11. Tighten the clamps on the heatshields.
12. Reinstall the right side floorboard assembly; tighten the bolts to factory specifications.
13. Make sure all the hardware (brackets, headpipes, heatshields, and baffles) have been tightened and
cleaned before starting the motorcycle.
IMPORTANT:
Cobra highly recommends using a Fi2000 Fuel Management System to help
eliminate lean conditions and popping sounds. Cobra Part# 92-1968.
Before starting your engine remove all fingerprints from chrome with a quality wax or chrome polish.
Failure to do so can cause discoloration. Due to fluctuations in fuel injection/carburetion settings,
timing, etc., Cobra Engineering does not warrant against chrome discoloration.
DOCUMENT NO. 0018
REV. B
FIGURE 1
ORIENTATION OF
EXHAUST
CLAMPS
SUPPLIED MUFFLER
BRACKET
EXHAUST
MUFFLER
SHORTENED
FOR CLARITY
RIGHT SIDE
FRAME
MEMBER
SUPPLIED
FLANGE
BOLTS
STOCK M8
FLANGE
BOLTS