Operation
12
Note
The reading will be slightly
higher on Channels 1 and 40
compared to Channel 20.
Note
When switched to SWR position
the meter needle should ideally
be as far to the left as possible.
Anything over 3 is not
acceptable. The antenna
indicator will light. A slight
antenna height adjustment
(higher or lower) may be
required. Repeat relcalibration
steps.
Repeat the same steps two through five
on Channel 1 and 40. This will check SWR for
all channels.
6
While still holding down the mic button, set
the S/RF SWR CAL switch to the SWR position,
to read the SWR reading.
5
29LTDBC_MANL.qx:29LTDDEJR_manual.qx 9/12/07 5:04 PM Page 12
