Cobra 20XTR Street Communicator, Руководство по эксплуатации

Страница: 10 / 15

15
Maintenance/
Adjustment
Maintenance
Maintenance and Adjustment
Your COBRA CB transceiver is specifically designed for
the environment encountered in mobile installations.
The use of all solid state circuitry and its light weight
result in high reliability. Should a failure occur,
however, review the following, then if necessary,
replace parts only with identical parts. Do not
substitute.
Check connections to the source of power and
make sure it is the 13.8 VDC required to operate
your radio.
Check the fuses in the DC power cord. The main
power lead (red ) has a 2 amp 3AG type fuse in its
holder. Use only the above specified type and size
fuse for maximum protection. Failure to do so will
void the warranty.
Make certain the microphone is properly
plugged in.
Make certain the antenna is properly assembled
and connected.
If you are unable to correct the problem, refer to the
SERVICE INSTRUCTIONS at the end of this manual for
the correct procedure for warranty and post-warranty
service from COBRA.
14
Operating Procedure to Receive
Be sure that power cord, antenna and microphone
are connected to the proper connectors before
proceeding further. The CB/PA switch should be in
the "CB" position.
Turn the radio ON by rotating the VOLUME
CONTROL clockwise.
Rotate SQUELCH CONTROL counterclockwise until
incoming signal
is heard.
Select the desired channel.
Set VOLUME CONTROL to a comfortable listening
level.
Operating Procedure to Transmit
Select the desired channel.
The receiver and transmitter are controlled by the
press-to-talk switch on the microphone. Press the
switch and the transmitter is activated; release
switch to receive. When transmitting (on a clear
channel), hold the microphone two inches from the
mouth and speak clearly in a normal voice.
Be sure the antenna is properly connected to the
radio before transmitting. Prolonged transmitting
without an antenna, or a poorly matched antenna,
could cause damage to the transmitter.
Operation
Operating
Procedure
to Receive
Operating
Procedure
to Transmit
20 XTR MANUAL.qxd 4/17/03 4:56 PM Page 14