Cobra 148GTL-DX, Инструкция по эксплуатации

Страница: 21 / 85

Fig. 5. Microphone plug pin numbers viewed from rear of pin réceptacle.
Be sure that the housing and the knurled ring of Fig. 3 are pushed back onto
the microphone cable before starting to solder. If the washer is not captive to
the pin réceptacle body, make sure that it is placed on the threaded portion
of the pin réceptacle body before soldering.
If the microphone jack is used to hold the pin réceptacle during the soldering
operation, best results are obtained when the connections to pins 1 and 3 are
made fïrst and then the connections to pins 2, 4 and 5. Use a minimum
amount of solder and be careful to prevent excessive solder accumulation on
pins, which could cause a short between the pin and the microphone plug
housing.
6. When ail soldering connections to the pins of the microphone plug are com­
plété, push the knurled ring and the housing forward and screw the housing
onto the threaded portion of the pin receptade body. Note the location of
the screw clearance hole in the plug housing with respect to the threaded hole
in the pin réceptacle b'ody. When the housing is completely threaded into the
pin réceptacle body, a final fraction of a tiim either clockwise or counter-
clockwise may be required to align the screw hole with the threaded hole in
the pin réceptacle body. When these are aligned, the retaining screw is then
screwed into the place to secure the housing to the pin réceptacle body.
7. The two cable clamp retainer screws should now be tightened to secure the
housing to the microphone cord. If the cutting directions hâve been carefully
followed, the cable clamp should secure to. the insulating jacket of the micro­
phone cable.
8. Upon completion of the microphone plug wiring, connect and secure the
microphone plug in the transceiver.
- 2 0
-