4
|
USER MANUAL
| XXL-Rehab Stand Tall
Use
The use of the XXL-Rehab Stand Tall is ideal in hospitals or
nursing homes.
The XXL-Rehab Stand Tall is designed to provide support
and security for persons weighing up to 325 kg when walk-
ing indoors.
Using the stand tall for persons weighing more than 325
kg may increase the risk of tilting or damage the stand tall.
The XXL-Rehab Stand Tall should be used on a plane
hard surface with a maximum inclination of 3.5 degrees, as
there may otherwise be a risk of tilting.
Description
The XXL-Rehab Stand Tall is equipped with four horizontal,
through-going bolts (two on each side) for height adjust-
ment of forearm supports and hand supports. The bolts are
locked with hand nuts.
Final assembly
The height of the stand tall’s forearm supports and hand
supports is adjustable by screwing the hand nuts off and
pulling the two horizontal bolts out of the frame. Then set
the forearm and hand supports at the appropriate position,
push the bolts through the frame and screw on the hand
nuts to secure the bolts.
The stand tall should not be used until the hand nuts have
been screwed tightly onto the bolts, as there may otherwise
be a risk of the forearm/hand supports loosening which may
cause the user to fall.
Please ensure that the curved heads of the bolts abut
closely against the frame, as there may otherwise be a risk
that the hand nuts cannot be tightened correctly and there-
fore work loose.
The hand nuts ought to be facing forward on the stand tall
to avoid injury to the user.
During use
Lock the brakes by bringing the locking bracket over the
brake handles, while keeping the stand tall braked.
The brakes must be locked when the user gets up/sits
down while using the stand tall as support.
The brakes may be difficult to activate for users with
limited strength of fingers. Such users should be instructed
in using the brakes with both hands.
The stand tall should be manoeuvred carefully across
obstacles such as thresholds, as there may otherwise be a
risk of tilting.
The stand tall is not designed for driving up and down
ramps inclining more than 3.5 degrees, as there may other-
wise be a risk of tilting.
The stand tall must only be used indoors and on plane
hard surfaces to avoid the risk of tilting.
Instructions for XXL-Rehab Stand Tall
To ensure proper use of the XXL-Rehab Stand Tall,
please read these instructions thoroughly before using
the product. In doing so, pay particular attention to
the warning notes marked with .
Also remember that in order to prevent the risk of
injury to the user, the stand tall may be operated only
by trained caregivers or aides or by individuals who
have been instructed in its proper use.
This product should not be used without proper
instruction from a healthcare professional.
Using the product for individuals weighing more than
the maximum weight-bearing capacity may pose a risk
for damaging the product.
Cobi Rehab assumes no responsibility for any damage
or injury caused by improper installation, assembly or
use of this product.
If components are damaged or missing, contact Cobi
Rehab immediately. Do NOT use substitute parts.
Cobi Rehab cannot be held liable for faults or acci-
dents occurring after repairs by service staff without
written authorisation from Cobi Rehab.
CAUTION
