COBHAM Sea Tel 4010W-17, Руководство по установке

Страница: 29 / 141

Installation 4010W-17 Installation Manual
3-9
2. To un-restrain the cross-level axis of the
antenna use a 7/16“ open end wrench to
loosen the nut on the top side of the locking
bar (either end of the bar).
3. Remove the bottom nut off of that adjustable
bumper.
4. Remove the adjustable bumper from the
locking bar.
5. Extract the locking bar from the underside of
the cross-level beam and retain these parts for
later re-use if it becomes necessary to stow
the antenna.
6. Verify that the antenna rotates (tilts left &
right from level) freely and easily a through its
full cross-level range of motion.
3.5. Cable Installation
3.5.1. Shipboard Cable Installation
CAUTION : Rough handling, tight bending, kinking, crushing and other careless
handling of the cables and their connectors can cause severe damage.
The cables must be routed from the above-decks equipment mounting location through the deck and
through various ship spaces to the vicinity of the below-decks equipment. When pulling the cables in place,
avoid sharp bends, kinking, and the use of excessive force. After placement, seal the deck penetration glands
and tie the cables securely in place all along the cable run(s).
3.6. Installing the Below Decks Equipment.
Installing the Antenna Control Unit, Base Multiplexer Panel and the Terminal Mounting Strip.
3.6.1. General Cautions & Warnings
CAUTION - Electrical Shock Potentials exist on the Gyro Compass output
lines.
Assure that the Gyro Compass output is turned
OFF
when handling and
connecting wiring to the Terminal Mounting Strip.
CAUTION -
Allow only an
authorized dealer
to install or service the your Sea Tel
System components. Unauthorized installation or service can be dangerous and may
invalidate the warranty.
3.6.2.
Prepare the Rack (or other location) for the ACU, Terminal Mounting Strip and base multiplexer panel.
Prepare the mounting locations for the other Below Decks Equipment throughout ship.
Preparing BDE Location