COBHAM SAILOR 6110 mini-C GMDSS, Руководство по установке

Страница: 28 / 112

Chapter 2: Install the system
16 Install the SAILOR 3027
2.3.2 Mount the SAILOR 3027 GMDSS Terminal
The SAILOR 3027 has one CAN connector and is designed primarily for
pole mounting.
• For mechanical drawings, see Mechanical outline drawing,
SAILOR 3027 on page 19.
• For information on wiring, see Connect the system on page 23.
• For part numbers of the mounting accessories, see Available parts on
page 86.
2.3.2.1 Pole mount 1”
The pole mount kit is included with your
SAILOR 3027. Follow the instructions
included with the pole mount kit.
1. Lead the cable through the pole and pole
mount adapter.
2. Connect the CAN cable to the terminal.
3. Mount cable relief for the CAN cable.
4. Mount the adapter on the terminal using screws.
5. Tighten the adapter to the pole.
Important
Do not tighten the screws more than
max. torque 2.5 Nm
when you mount the SAILOR 3027. Tightening the screws
too much may cause damage to the housing of the
SAILOR 3027 and thus impair the protection against water
intrusion. If you are mounting the terminal directly on a plain
surface, use a large spacer (order no. 403027-921) between
the mounting surface and the SAILOR 3027 and tighten the
screws to torque
1.5 - 2.5 Nm
.
Note The connector is waterproof.
Do not attempt to seal the
connection any further.