Setup with the web interface for PC
98-143492-D
Chapter 4: Setup and operation
4-11
Setup a
nd op
eration
2. Set the Heading,
Position, Manual pointing and Fixed installation
:
3. Click
Apply
to save the new settings.
4.1.7
Administration
In this section of the web interface you can configure the following administrative settings:
•
Access to the administration settings (user name, password)
•
User permissions (guest login)
•
Import and export of a system configuration
•
Access to the administration settings (user name, password)
You can logon as an administrator or as guest (user name: guest, password: guest). The
Administration settings require an Administration user name and password. To log on as
administrator, do as follows:
1. Open your Internet browser and enter the IP address of the EXPLORER 5075GX:
http://192.168.0.1.
2. Enter the Administration user name
admin
and password
1234
(default).
3. Click
Logon
.
4. Select
ADMINISTRATION
.
Item
Description
Heading
(Compass
direction)
Mode
Automatic
- magnetic heading is used (default).
Manual
- enter a value for the direction of the EXPLORER 5075GX as
an alternative to the magnetic heading (0 to 360 degrees, precision
±20°). 0 degrees points North, 180 degrees points South.
None
- Full azimuth scan
Position mode GNSS
- GNSS module is used for current position (default).
Manual -
enter values from other position source. (Accuracy should
be better than 50 m.)
Manual
pointing
This turns off the motors in the antenna and you must make a manual
pointing using the hand crank. See
Fixed
installation
The EXPLORER 5075GX automatically allows the GX modem to enter
the network after reboot in case of a temporary power loss. No user
action is required.
Fixed installation
is allowed after the EXPLORER
5075GX has been pointed to the satellite.
Table 4-6: Web interface: SERVICE > Navigation
Note
In order to ensure that the EXPLORER 5075GX is pointed correctly, make sure
that
Fixed installation
is not selected during manual pointing of the
EXPLORER 5075GX.
