AA95-1000TSO Single Channel Audio Controller
Installation and Operation Manual
Rev 1.01
CONFIDENTIAL AND PROPRIETARY TO COBHAM
Page 2-1
Section 2 Installation
2.1
Introduction
Information in this section consists of unpacking and inspection procedures, installation procedures, post-
installation checks and installation drawings for the AA95-1000TSO Single Channel Audio Controller.
Review all notes, warnings and cautions.
2.2
Airworthiness Limitations
The Airworthiness Limitations Section is FAA approved and specifies maintenance required under 14
CFR §§ 43.16 and 91.403 of the Federal Aviation Regulations unless an alternative program has been
FAA approved.
There are no new (or additional) airworthiness limitations associated with this equipment and/or
installation.
Maintenance of the AA95-1000TSO
Single Channel Audio Controller is ‘on condition’ only. Periodic
maintenance of this product is not required.
2.3
Installation Procedures
2.3.1
Warnings
WARNING:
High volume settings can cause hearing damage.
Set the headset volume control to the minimum volume setting prior to
conducting tests, and slowly increase the headset volume to a
comfortable listening level.
2.3.2
Cautions
CAUTION:
Do not bundle any lines from this unit
with transmitter coax feed lines. Do not
bundle any logic, audio, or DC power lines from this unit with 400 Hz synchro
wiring or AC power lines. Do not position this unit next to any device with a
strong alternating magnetic field such as an inverter, motor or blower, or
significant audio interference will result.
In all installations, use shielded cable exactly as shown, and ground only as
indicated. Significant problems may result from not following these guidelines.
Failure to follow the installation and wiring instructions provided in this manual
for power and ground connections, including the rating of the circuit breaker,
may lead to damage in the power input circuitry of the unit.