COBHAM 3.8m Offset Antenna, Руководство по установке

Страница: 10 / 24

10
www.cobham.com/patriot
Apply wax here
to aid in sliding
radial beams in to hub
Apply wax here
to aid in sliding
radial beams in to hub
1. Fasten (4) ANGLE,3.8M OFFSET HUB (pt# 238214-12
)
to each Radial
Beam as shown, using (4) 3/8in shoulder (1) 5/16” washer, and nut per.
2. Adjust the Hub into the position shown, and select 3.8M OFFSET RADIAL
BEAM C ASSEMBLY (pt#238213), and place into the outermost location
inside the Hub. Fasten using 3/8in shoulder bolt hardware, (1) 5/16”
washer, nut per lose. Do the same with the opposing 3.8M OFFSET
RADIAL BEAM C ASSEMBLY (pt#238213).
NOTE: Hard to reach hardware can be accessed by reaching inside and
around the end of the Radial Beam to reach the back side.
3. Repeat step 2 for 3.8M OFFSET RADIAL BEAM B ASSEMBLY (pt# 238211)
3.8M OFFSET RADIAL BEAM A ASSEMBLY (pt# 238210)
4. Tighten all Radial Beam hardware in steps 1 through 3.
ANGLE,3.8M OFFSET HUB
(238214-12)
RADIAL BEAM
ASSEMBLY
NOTE: Shoulder bolts are fastened from the
inside of the Hub with the washers and nuts
on the outside.
All hardware can be found in bag
#3HP38011
Radial Beam Install