Cobalt Digital Inc HPF-9000, Руководство по эксплуатации продукта

Страница: 39 / 54

HPF9000-OM (V1.8) HPF-9000 PRODUCT MANUAL
2-21
Installation and Setup
Setting Up Network Remote Control
12.
The frame is now ready to access and control cards.
Network Controller Card Address Mode Switch
Figure 2-8 is a general reference showing the various network modes
available using the card setup DIP switches. For most installations, it is
recommended to follow the procedures above for setting up the card network
communications. Figure 2-8 shows settings for these modes as well as special
alternate modes.
Figure 2-8 Network Controller Card DIP Switch Overview
SETUP_ADDNEWIP3.PNG
New IP address now
assigned to frame
Newly assigned user IP
address
DIP switches SW-1 and SW-2 provide various network settings for the card. For reference, these are described below. Note that for
normal installations, manipulation of these switch as shown in the procedures above is all that is required.
12 Static IP address
assigned by
user
34
12 IP address
assigned by
DHCP
34
12 IP address set to
factory fixed factory:
192.168.2.1
34
12
34
Local/private
address set to
fixed factory:
10.1.2.1