343 Owner’s Manual
3-21
Operating Information
1. Switch Panel and Functions -
The switches are
described starting from left to right and clockwise.
ACC (Accessory) -
This switch is available to
operate a switched accessory item.
CAPT CALL (496 hp only) -
This switch
determines the routing of the engine exhaust. In the
ON position, engine exhaust is routed through the
thru-hull pipes. This position produces the most
engine power, but is not acceptable near shore or
on inland lakes and rivers.
In the OFF position, engine exhaust is routed
through the hub of the propeller. This position
releases the exhaust underwater providing a
quieter engine sound.
Be sure to check local regulations regarding noise
restrictions before operating this system.
ENGINE COMP “Light”
- This switch provides
illumination within the engine compartment.
COCKPIT “Light”
-
This switch provides
illumination within the cockpit.
DOCK “Light” (Optional) -
This switch operates
the docking lights. Docking lights are to be used for
docking only. It is illegal to use your docking lights
while cruising.
NAV/ANC “Lights” (Navigational Lights)
-
This
three position switch activates the navigational
(running) lights and the anchor light. After installing
the light, press the switch toward the "NAV." Press
the switch toward the "ANC" and the
anchoring/mooring light (360° white) will illuminate.
Navigational Lights - You must use your
navigational lights (running lights) when operating
your 343 boat between sunset and sunrise, and
when day time visibility is limited. Also, check with
the local authorities before operating your boat, for
other requirements concerning the use of
navigational lights.
The navigational lights are identified by a red light
on the port side of the vessel, and a green light on
the starboard side.
Anchor/Mooring Light - All boats at anchor or
moored must display a proper white anchor light.
The anchor light (all around light) is the white light
located aft of the cockpit. The anchor light must be
visible from 360° and will remain on when operating
the navigational lights.
DEPTH SOUNDER -
To see your options - shallow,
deep, keel depth and units - toggle the top switch to
down position. To set each option to desired
reading toggle switch to up position. For detailed
instructions, refer to the information included in
your owner's packet or consult your Cobalt dealer.
DEPTH FINDER INDICATOR -
Displays the depth
finder information.
AIR/WATER TEMPERATURE INDICATOR
-
Displays the air/water temperature information.
A
WARNING
Avoid the risk of injury, death or
equipment damage. If the safety of you
or others depends on running the
engine during an abnormal condition,
make the right decision on saving
equipment or lives. Do not jeopardize
the safety of you or others to protect
your boat.
NOTICE: For 500 hp and up
engine options, the CAPT CALL
switch works as follows:
• ON - Exhaust routed through
propeller hub
• OFF - Exhaust routed through
thru-hull pipes
CAUTION
Avoid damage to the exhaust system.
Do not switch the exhaust above 3,000
rpm.
Operate the boat between
sunset and sunrise using your
navigational lights.
Navigational lights are legally
required to indicate direction
and right-of-way at night.
COB_343_OM_forWeb.book Page 21 Monday, June 12, 2006 10:20 AM
