Cobalt Digital Inc 26SD, Руководство пользователя

Страница: 92 / 134

Cobalt_OM_preprint_shell.fm Page 2 Wednesday, March 1, 2006 5:39 AM
3
-
36 26SD Owner’s Manual
COBALT
26SD
SPORT DECK
S
ECTION
3
Electrically Operated Head
1. Make sure inlet and outlet seacocks are all
open.
2. Push the button to operate.
3. Operate until the bowl is completely flushed and
the discharge pump has scavenged water from
the bottom of the bowl.
The Jabsco electric marine toilet will provide years
of trouble-free service if properly used. It will handle
waste and toilet tissue. It will NOT handle rags,
sanitary napkins or hard, solid objects.
If the bowl does not pump out and begins to fill,
partially close the inlet valve until the bowl is
cleared and completely pumped out. Then operate
for a few seconds with both valves open to clear the
entire toilet and discharge system. For maximum
safety, when the toilet is not in use or the vessel is
unattended, close both the inlet and discharge
seacocks.
To drain for winter lay-up, close the inlet valve and
operate for a few seconds until all water is pumped
out.
After long periods of nonuse, the toilet and pump
may dry out. To ease initial start-up, put about 1 qt
(1 L) of water in bowl and let stand a while before
initial use.
Your boat is fitted with a waste holding tank. It is
emptied through the deck plate fitting marked
“WASTE”. Waste is pumped from the head through
a sanitary waste hose to the top portion of the tank.
A sanitary waste hose is attached to the bottom of
the tank, and runs to the dockside pump-out plate.
An overboard vent keeps the tank at atmospheric
pressure regardless of waste levels.
The optional macerator system allows the
discharging of waste water from the waste tank
directly overboard. For additional operating
information, refer to the macerator operator’s
manual.
All components of the waste system are made of
materials specially formulated to prevent odor
permeation. It is strongly recommended you
regularly add chemical to your tank by flushing it
through the head. The chemical helps to control
odor and break down the waste. Follow the
manufacturer’s instructions on the chemical before
using.
A waste tank level monitor is installed to provide a
visual indication of the amount of waste in the tank.
The ignition key may need to be on for the monitor
or water pump to work.
VacuFlush Head
1. Make sure the water pump is on.
2. Turn on the VacuFlush rocker switch, located on
the panel. A red light will turn green when the
system is ready.
3. To charge the head, raise the foot pedal on the
lower left side of the bowl.
4. To flush, depress the foot pedal.
A
CAUTION
Avoid damage to the waste system. Do
not flush into a full holding tank.
NOTICE: Overboard discharge
of waste water should only be
used in approved areas. It is
your responsibility to comply
with local regulations regarding
the discharge of waste. You
could be fined if your boat has
an operable overboard
discharge system.
To avoid a fine, remove the
handle of the seacock (in the
CLOSED position) or disable
the system by other means such
as locking the
“ Y ” valve in the
“
pump-out
”
position.
A
CAUTION
Avoid damage to the waste system. Do
not flush into a full holding tank.