SAFETY WARNING
Coaster puts your Childs safety as a top priority. Our bunk beds have been tested by an
independent laboratory and are certified to be in compliance with ASTMF - 1427, "Standard
Consumer safety Specification for Bunk Beds" and U.S. Government specifications 16 Code of
Federal Regulations, parts 1213 and 1513.
1. Follow the information on the warning attached to the upper bunk end structure
and on the carton. Do not remove this label.
2. Always use the recommended size mattress or mattress or mattress support or
both to help prevent the likelihood of entrapment or fall.
3. Ensure thickness of mattress and foundation combined does not exceed 6" and
mattress surface at least" inches below upper edge of guardrails.
4. Do not allow children less than six years of age to use the upper bunk.
5. Prohibit more than one person nipper bunk.
6. Periodically check and ensure that the guardrail, ladder and other components
are tight .
7. Do not allow horseplay on or under the bed and prohibit jumping on the bed.
8. Always use the ladder for entering and leaving the upper bunk.
9. Do not use substitute parts. Contact the manufacturer or dealer for replacement
parts.
10. Use of a night light may provide added safety precaution for a child using upper
bunk.
11. If the bunk bed will be placed next to a wall, the guardrail that runs the full
length of the bed should be placed against the wall to prevent entrapment between
the bed and the wall.(This applies only the bunk beds without two full - length
guardrails.)
12. Always use guardrails or both long sides of the upper bunk.
13. The use of water or sleep flotation mattress is prohibited.
14. Keep these instructions for future reference.
STRANGULATION HAZARD:
15. Never attach or hang items to any part of the bunk bed than are not designed for
ace with the bad for example, but not limited to hooks, belt and jump ropes.
SIZE OF MATTRESS AND FOUNDATION:
Use only mattress which is 37
1
/
2
" - 38
1
/
2
" in width and 74" - 75" in length. The total
thickness of mattress and foundation (slat kit, bunk board, ect. ) combined must not exceed 6"
Note: There must be at least 5" from mattress sleeping surface to top edge of guardrail.
REPLACEMENT PARTS
Replacement parts, including additional guardrails may be obtained from any Coaster
Furniture Dealer.
PAGE 5 OF 6
www.coastercompany.com
