FITTING GUIDE
CONNECTING COMPONENTS AND WIRING
LIT-FG-BLU-e
6. CONNECTING THE POWER SUPPLY TO THE TRANSFER CABLE AND
240V SUPPLY
7. SWITCHING THE SYSTEM ON
We advise a qualified electrician to connect the 240v supply to the power supply unit.
Only the white and brown wires are required from the transfer cable, the other wires are not required so please
isolate.
The white wire connects to the V+ terminal of the power supply unit and the brown wire connects to the V-
terminal.
The 240v feed will require a live to the ‘L’ terminal and neutral to the ‘N’ terminal.
Once the system is properly wired, voltage can be applied (240v), a blue light should be visible on the power supply
unit and a blue light visible on the finger scanner, at this point an audible click should be heard from the motor. The
system is now in test mode, placing a finger on the scanner should activate a cycle on the motor.
If the test fails check all wiring has been connected correctly.
Door manufacturers or electricians have a test mode for the basic function – i.e. opening the door. The test mode is
only possible within the first ten minutes after the voltage has been applied. This function is then deactivated after
this time has elapsed or after the system has been activated.
12
BLU-e Fitting Guide
