WEATHERPAK
®
-2000 USER
MANUAL
Coastal Environmental Systems (206) 682-6048
- 17 -
Van Mount Setup
1)
Remove the wind vane from the case. Place the propeller on the front shaft
screw the nut into place on the
propeller shaft to secure the propeller.
2)
Plug the wind vane into the top of the WEATHERPAK
. There is an alignment pin and slot inside the
connector to assure a proper and aligned fit.
Be certain that the wind vane is plugged all the way in. DO
NOT rotate the wind vane when installing or removing.
3)
Align the slot on the WEATHERPAK
with the guide pin on the quick release and push straight in. (DO
NOT “screw” the WEATHERPAK
onto the quick release.) This is a good sealed fit and may require an extra
push - then
push the arms of the clamp down
to assure a tight fit. DO NOT rotate the WEATHERPAK
or
tower when installing or removing.
4)
The WEATHERPAK
is now running and is sampling. When the WEATHERPAK
is removed from the
Quick Release, it will stop sampling and shut itself off.
5)
The Van Mount Quick Release is permanently mounted on a vehicle. Coastal supplies a 1-½” female SPT.
Van Mount Quick Release
