2/3
7
–
Remove bolt, and reposition bolt and nut in desired hole
to obtain desired bed height.
8
–
Hold bolt in new hole position with vice grips and tighten
nut with socket.
9
–
Reposition the plastic cover back to its original position
as it was in step 2. And re install only the 2 screws at the
bottom of the leg.
Please Note:
To reach maximum rigidity, this table base has to be
screwed or bolted down to a solid floor.
10 - Once the table leg is secured to the floor, slide down the
plastic base cover until it makes contact with the floor of the
caravan, making sure the small hole in the plastic cover is
aligned with the bolt thread in the base, and install the black
base knob.
11 - Proceed to attach the table top slide mechanism to the
leg. Position the table top slide mechanism on top of the table
leg, lining up the four holes in the slide mechanism with the
four screw holes in the table leg. Using the four screws you
removed in step 2, fasten the table top slide mechanism to
the table leg.
12
–
At each corner of the slide mechanism, locate the two
screw holes. These are the fixing points for your table top.
