15
Fade (Blue-Green)
Solid White
Solid Pink
Solid Purple
Solid Blue
Solid Dark Blue
Solid Teal
Solid Green
Slow Fade
Quick Fade
Quick Change
Fast Strobe
OWNER’S MANUAL
2017
PROGRAMMING THE TUBLICIOUS FUNCTIONS
HEAT MODES (VIA THE PROGRAM BUTTON)
Standard Mode:
maintains the desired temperature. Note that the last measured spa temperature displayed is current only when
the pump has been running for at least 1 minute. “
STD”
will appear on the display momentarily when you switch into Standard
Mode.
Economy Mode:
heats the spa to the set temperature only during filter cycles. “
ECN”
will alternate with the temperature when the
temperature is current. “
ECN
” will alternate with “- - -” when the temperature is not current.
Pressing “Jets” while in economy mode puts the spa in
Standard-In-Economy-Mode
, (“
SE
”) which operates the same as Stan-
dard Mode, then reverts to economy mode after 1 hour. During this time, pressing and releasing “Program” will revert the mode to
Economy immediately.
Sleep Mode:
heats the spa to within 20°F/11°C of the set temperature only during filter cycles. “
SLP
” will alternate with the tem-
perature when the temperature is current. “
SLP
” will alternate with “- - -” when the temperature is not current.
The Program button is used to switch between Standard, Economy, and Sleep modes. Press and release “Program” to enter
Mode Programming, press “Down” to cycle through to desired mode (LED display flashes until confirmed), then press “Program” to
confirm selection.
Filter Cycles & °F vs. °C (via the Program Button)
The pump will run in low speed during filtration.
The first filter cycle (“day”) begins 6 minutes after the spa is powered on. The second filter cycle (“night”) begins 12 hours after the
first one. Filter duration is programmable for 0.5-6.0 hours (“
F0.5
”-“
F6.0
”). The default filter duration is 2 hours.
The
Program
button is used to set filtration cycles. Hold down “Program” for at least 3 seconds. When Filter
Duration appears, press “Down” or “Up” to select the filter duration. Press “Program” to select the number of filter cycles. The
display will show “
dn
” (both “day” and “night” cycles); “
d
” (“day” cycle only); or “
n
” (“night” cycle only). Press “Down” or “Up” to
adjust.
The
Program
button is also used to change between °F and °C. After filtration is set, press “Program” to select Fahrenheit (“F”) or
Celsius (“C”). Press “Down” or “Up” to adjust. Press “Program” again to exit the programming mode.
The “Filter” LED indicator lights when either filter cycle is running.
CAUTION
: Long and/or numerous filter cycles could cause overheating of the Tublicious, especially in
hot climates.
Dynamic L.E.D Light
Tublicious is equipped with a main LED light that controls the colors by pushing the light button on the keypad.
To Operate Light Functions:
Press
Light
key once and the first color pattern sequence will be displayed
To activate the next color pattern, press
Light
key again. Light will turn off, then press
Light
key within 3 seconds to activate the
next color sequence.
The Color Pattern Sequences are:
