OWNER’S MANUAL
INFINITY COLLECTION
2021
8
GATE VALVES:
Red with a grey handle is
located at the inlet and outlet of the pumping
system. Used while servicing the spa equipment,
the valves open or close the water flow to the
equipment. To remain open for normal use, turn
fully counterclockwise.
KNIFE VALVES:
A white “T”-handled valve,
same functions as Gate valve (see above), except
to open them you pull up on handle.
HEATER:
The electronically controlled heater
raises the temperature of the spa to the desired
setting.
LEDs:
LEDs and their special lenses can be
used to achieve the desired mood lighting in the
spa and spa jets.
SKIMMER:
This is the rectangular outlet at the
water level. The skimmer removes surface debris
to the filter. The water level in the spa should be
kept ½ to ¾ up on the skimmer for optimum
operation.
SUCTION:
During operation of the equipment,
the suction works in conjunction with the skimmer
to draw water from the bottom of the spa through
the filter, keeping the spa sparkling clean.
NECK JET:
Direction-controllable jet for soothing
neck massage.
ADJUSTABLE CLUSTER JET:
Our adjustable,
high-intensity hydrotherapy jet.
DIRECTIONAL JET:
Provides a straight flow for
a therapeutic massage
ROTATIONAL JET:
Provides a Unidirectional
circular therapeutic massage.
MASSAGE JET:
Delivers massage in staccato
bursts over a narrow, focused area.
VOLCANO/WHIRLPOOL JET:
high-output jet
designed for foot and leg massage.
LAMINAR FLOW:
A thin stream of water that
arcs from the spa lip.
PREPARATION, SET-UP AND LOCATION
FOR YOUR NEW SPA:
You want to keep in mind how you intend to use the spa and
plan the location accordingly.
How close is the spa from the exit or entrance to your house?
(consider the cold weather)
Is the path to your spa clean of debris, sand, grass? (so as
not to track into the spa)
Is there protection from wind, inclement weather?
Can neighbors or passersby see the spa?
NOTE:
Allow for service access:
Many spa owners enjoy
placing their spa in a decorative enclosure or a deck. Keep in
mind that you need to have access to the equipment for
maintenance and the spa should be able to be moved or lifted
without destroying the special enclosure or its surroundings.
You should discuss this with your dealer when designing the
location. Extension cords are not to be used in conjunction with
the operations of the spa. Low voltage damage could result and
this is not covered by warranty.
NOTE:
All components must be 120V; No 240V components
allowable.
240VAC:
Depending on the model of spa, it will require
either a 40 Amp, 50 Amp, or 60 Amp dedicated circuit breaker,
GFCI, with the proper wire size based on the length of the run.
The electrical circuit must be installed by a certified electrician
and approved by a local building or electrical inspector.
DISCLAIMER:
The pictures displayed above are for reference purpose only. Some parts may be different depending upon the spa model.
