Using the Monitor
Power and Charging
The first time you use the monitor, use the wall adapter or a
powered PC port and the USB cable to plug it in.
The monitor has a built-in rechargeable battery. When the screen
displays low battery, it should be recharged. The monitor can be
used while charging.
Turning the Monitor ON / OFF
Press the power button to turn the power on or off. When
powered on, the display will show a 30 second count down.
After the countdown is complete, you can change settings.
Setting the CO2 Alarm Level, Date and Clock
Press the MODE button for two seconds to begin. The first
setting is the CO2 alarm level. Press the left and right arrow
buttons to select the digit to change. The selected digit will
flash. Press the up and down arrows to change it.
Press the MODE button again for 2 seconds to move to the
date and clock values. Again, use the MODE button to
change between values and the up and down arrows to
change them.
When complete, press the MODE button to save
your changes and return to the normal display. The CO2 Alarm
Level, Date and Clock can also be set using the software. See
instructions at the end of this manual.
Using the CO2 Alarm
The CO2 alarm can warn you if carbon dioxide levels are too
high. If the CO2 level goes over the level you set, a buzzer
will sound. Press the left arrow button to turn the buzzer on
or off.
The factory default carbon dioxide concentration alarm value
is 2,000ppm. See below for recommended CO2 levels
5
www.CO2Meter.com
www.CO2Meter.com
6
