User’s Manual
Page 6
2.
The contacts on the NO_FAULT terminal are closed. You can configure a relay
and read the NO_FAULT signal from the ACORN, or you could just put a jumper
on it if not used.
The board can be activated by the axis enable or the NO_FAULT signal, or a
combination of both signals. It could also be hardwired to be permanently active if both
inputs are jumped.
6.1 Operation Sequence:
1. Once the board gets enabled, it will take 5 seconds in order for it to start
monitoring for a fault. This to preserve compatibility with some drivers which
may need time to activate.
2. If a driver faults, the relay will trip and the green LED will go off. An LED
indicating the which driver or drivers triggered the fault will light next to the RJ45
of the axis that tripped the fault.
