XNET User Manual
23 /
30
Item
Sub Item
Description
IP Address
Configuration
Enable DHCP
Turns DHCP on or off.
Check DHCP checkbox to get an IP address
automatically from the network using DHCP protocol.
Obtained IP address can be viewed by IP Installer.
(Note) If the network does not use DHCP server, the
product will wait for server’s response for two
minutes and restart with its previous IP address.
IP Address
Enter an IP address.
Configure IP address after checking IP address
range configuration of the router where the XNET
product is connected.
HTTP Port
Enter HTTP Port to access the webpage.
Default port is 80, and any other port number has to
be entered at the end of the ip address when
accessing. (e.g.: When using HTTP Port 8080, enter
http://192.168.123.100:8080)
Subnet Mask
Enter Subnet mask. IPv4 Address
Use this when you want to access only from the
same subnet by masking out upper portion of the IP
address.
Use 255.255.255.255 when you want to connect
from one PC only.
Default Gateway
Enter default gateway.
Primary
DNS Server
Enter primary DNS address.
Table 1-9
