CNB IPM3063N, Инструкция по эксплуатации, Страница: 21 / 82

◎ This configures XPEED-XNET’s network related parameters.
Click [TCP/IP] button to open the page shown in below figure.
Configuring the Network (TCP/IP) parameters
41 40
Recalls previously saved configurations.
- Reset
Applies and saves changes.
- Save
Enter Ethernet Address.
MAC Clon MAC Address
Enter Host name.
User
the host name
Host name
Configuration
Enter address of NTP (Network Time Protocol Server).
NTP server is used when “Synchronize to NTP Server” is selected in
Date&Time page.
NTP address
NTP
Configuration
Enter secondary DNS address.
Secondary DNS
Server
Enter primary DNS address.
Primary
DNS Server
DNS
Configuration
Enter the address of Default gateway.
Default gateway
Enter Subnet mask.
Use this when you want to access only from the same subnet by Masking
out upper portion of the IP address.
Use 255.255.255.255 when you want to connect from on PC only.
Subnet mask
Enter an IP address.
Configure IP address after checking IP address range configuration of the
router where the XPEED-XNET product is connected.
IP address
Turns DHCP on or off.
Check DHCP checkbox to get an IP address automatically from the
Network using DHCP protocol. Obtained IP address can be viewed by IP
Installer.
(Note) If the network does not use DHCP server, the product will wait for
server’s response for two minutes and restart with its previous IP Address.
Enable DHCP
(default)
IP Address
Configuration
DESCRIPTION ITEM