CMS Marine SonicShield I Micro, Руководство пользователя

Страница: 7 / 15

Issue 3 16/6/14 - CMS Marine - +44 (0) 1452 380100 – info@cmsmarine.co.uk
Page 6
It is advised to clean the prepared area of the hull and the transducer ring with an alcohol based solvent i.e Acetone
(Not supplied).
PLEASE ENSURE YOU TAKE NOTE OF THE MANUFACTURERS SAFTEY INSTRUCTIONS WHEN USING
THESE PRODUCTS.
Place the transducer assembly on this newly prepared area and draw around the ring to give you a guide for the
epoxy later in the assembly.
Once you have prepared the hull you are now ready to apply the
adhesive plastic disc. Screw the transducer into the ring until it sits slightly proud of the nut. Peel off the white
backing paper and fix the plastic disc to the centre of the transducer face. Smooth the edges of the disc so that they
are touching the solid black ring of the transducer nut as show below.
The purpose of the plastic disc is to ensure you have a solid contact to the hull of the boat. Later in this guide you will
be applying epoxy resin to the boats hull and this plastic disc will protect the transducer face from the epoxy resin.
Using the epoxy resin supplied you will now need to apply epoxy to the transducer ring ONLY , ensuring you DO NOT
apply any epoxy to the plastic covering, applying epoxy to the plastic covering will create bubbling / rippling which
will decrease effectiveness. Be aware of the rapid setting time of the epoxy resin and only mix enough for immediate
use.
After preparing the hull area, place the
transducer and nut in the proposed position
and draw around the outside of the nut to
give you a guide.