AN113
Rev 1.0 | Page 14 / 34
www.cmostek.com
Notes:
1.
Install the latest RFPDK on the PC (refer to “Section 7.1 Installation Steps”) and connect the USB programmer to the PC
with a USB cable, then start the RFPDK on the PC.
2.
The study function is enabled in this scheme, while the Sync ID on both of the Tx and Rx side are set to be the same by
default. In order to experience the study function, the user should set the Sync ID to the different values before burning
the configurations to the Tx and Rx devices. Pin11 (K1) is assigned as the study button in Periodic Tx scheme.
2.5 Normal
The user can experience the normal scheme, by setting the Button Mode on the RFPDK to Normal. In this scheme, each LED
on the CMT2250A-EM is controlled by one push button on the CMT2150A-EM respectively. The push buttons are shown and
described in the figure/table below:
Figure 16. EMs Used to Experience Normal Scheme
Table 9. Push Buttons Functions Definition of Normal Scheme
Push Button
Function Description
K1
Turn LED2 on, turn LED3 and LED4 off.
K2
Turn LED3 on, turn LED1 and LED4 off.
K3
Turn LED4 on, turn LED2 and LED3 off.
K4, K5, K6
Not used in this scheme, as there are only 4 LEDs on the CMT2250A-EM
Please note that the configuration for the Normal scheme is not provided by the RFPDK by default. If the user want to evaluate
the Normal mode, the user can follow the below steps to configure the Normal scheme, as shown in figure below
