Evaluation Kit for CMX608/618/638
EV6180/6380
2016 CML Microsystems Plc
7
UM6180/5
3.
Quick Start
This section provides instructions for users who wish to experiment immediately with the
evaluation kit. A full description of the kit hardware and software is contained in section 6 of this
document.
3.1.
Setting-Up the EV6180/6380 with the PE0003
Before commencing with setting up the hardware and software please refer to section 4 of this
document and ensure that the jumper tab settings on the board are the same as the default
positions listed in Table 3.
Extract the PE0003 support package to a directory on the host PC.
Plug the right-angled connector J3 on the EV6180/6380 board directly into right-angled connector
J3 on the PE0003. Connect the output of a regulated DC power supply to J2 on the EV6180/6380
and J11 on the PE0003. The supply voltage should be set at +5V.
Attach the USB cable between connector J9 on the PE0003 and the relevant USB port on the host
PC. Apply voltage to both cards. D8 will illuminate on the PE0003 and D3 will illuminate on the
EV6180/6380.
After power is applied to the EV6180/6380 and PE0003 a request will be displayed on the PC
monitor to install the USB driver. The driver will be located in the directory into which the support
package has been extracted, under the ‘Driver’ sub-directory. Note that during driver installation a
message box may be displayed containing a message that the software being installed does not
pass Windows Logo testing. Click on the ‘Continue Anyway’ button.
Once installation is complete the ES0003xx application can be started. When prompted press the
reset switch SW1 on the PE0003 and click the ‘OK’ button on the GUI. The kit is now ready to use.
3.2.
Adjustments
None.
3.3.
Operation
Refer to section 6.
