CMi C-EKS-2000/35, Оригинальное руководство пользователя

Страница: 55 / 224

GB
55
Trunks lying flat on the ground
– Cut into the trunk halfway, then turn over
and saw through from the opposite side.
Propped-up trunks
We recommend that you place trunks to be
sawed through on sawhorses. If this is not
possible, the trunk should be lifted with the
help of supporting branches and placed over
trestles.
In area A, first cut through approximately one
third of the trunk diameter from above down-
wards, then make the final cut from below
upwards. In area B, first cut through approxi-
mately one third of the trunk diameter from
below upwards, then saw through from
above.
Removing branches
• Always work on the side opposite the
branch in question.
• Begin at the bottom of the trunk and work
upwards.
• Always guide the saw from above down-
wards through the wood.
When removing the branches from trunks
which are lying down, first saw off the free
branches sticking up in the air. Only saw off
supporting branches when the trunk is sawed
in lengths.
Cleaning and maintenance
Cleaning and maintenance overview
After each use
Regularly, depending on the conditions of
use
Cleaning
Cleaning the device
– Remove coarse dirt.
– Wipe down the device with a slightly
damp cloth.
Cleaning the oil guide groove of the saw
rail
– Remove the saw rail.
– Clean dirt from the oil guide groove of the
saw rail with a suitable tool.
– Replace saw rail(
►
Assembling the saw
rail and saw chain – p. 51 ).
Re-tensioning the saw chain
►
P. 4, item 5
– Loosen the fastening nut (5) by approxi-
mately one turn.
– Lift the tip of the saw rail slightly.
– Tighten the tensioning screw for chain
tension (16) until the chain lies on the
underside of the saw rail.
Lubricating chain wheel
►
P. 5, item 9
NOTICE! Device damage! Make
sure that the saw rail does not touch
the ground while you are sawing
through the trunk!
DANGER! Risk of injury! Do not
saw any trunks under tension! Splin-
tering wood or a twisted saw rail can
cause extremely severe injuries!
DANGER! Risk of injury! Branches
that are high up or under tension can
wedge the saw chain in the wood!
DANGER! Risk of injury!
Before
any maintenance or cleaning work:
– Pull out the plug.
– Let the device cool down.
A B
DANGER! In the interest of your
own safety!
Only perform the main-
tenance work described here your-
self.
Any other work, especially motor
maintenance and repairs must be per-
formed by a trained professional.
Improper work can cause damage to
the device and thus also injuries.
What? How?
Clean the device
►
Cleaning the de-
vice – p. 55
What? How?
Re-tension saw chain
►
Re-tensioning the
saw chain – p. 55
Clean oil guide
groove of the saw rail.
►
Cleaning the oil
guide groove of the
saw rail – p. 55
Sharpen the saw
chain.
►
Sharpening the
saw chain – p. 56
NOTICE! Device damage! To clean
the saw rail, use only a plastic spatula,
never a steel tool.