8
SETTING CODES USING A MANUAL SEARCH
(only to be performed if the speci
fi
c code could
not
be found)
CHECK
Check that the other buttons correspond to the functions of the original remote control; if not, it is likely that the code
found is incorrect, but is used for a very similar device. In that case, repeat the procedure from point
2
.
If the manual search for the code is successful, obtain the code in use by following the
DISPLAY CODE IN USE
procedure and make a note of it inside the battery cover.
1.
Switch on the device to be programmed:
- if it is a
TV
,
SAT
or
TER
select a programme
- if it is a
DVD
insert a
DVD
.
2.
Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter the
code for.
3.
Release the button. The indicator light will
fl
ash. Point the
remote control at the device and press the
ON/OFF
key
(or
PLAY
if it is a
DVD
). If the device does
NOT
switch off
(or if the
DVD
does not start playing) press the same but-
ton again slowly (it may be necessary to press the button
several times).
4.
When the device responds correctly, press
OK
. Three
long
fl
ashes indicate that the operation has been carried
out
correctly
.
or
6 SEC.
or
or
or
or
WARNING
- separate data with a
comma
and be
as precise as possible
so that the information system can search for
data and answer correctly.
Send the
SMS
to
0039 345 7518893
and wait for a reply by
SMS
.
After receiving the code list by
SMS
, set the
fi
rst code on the remote control as described in the
ENTERING THE CODE
DIRECTLY
procedure.
Stand in front of the device already turned on with the
CME
remote control and press the
ON/OFF
button (or the
PLAY
button if the device is a
DVD
). If the device does
NOT
turn off (or if the
DVD
does not start playing), try to set the next code
on the
SMS
list on the remote control. Repeat the operation until the device responds. When the device responds, con
fi
rm
that the other buttons are also operating correctly. If so, the remote control is ready to use. Otherwise, an inaccurate code,
used for a very similar device, is being entered; ignore the SMS list and see paragraph
MANUAL SEARCH
to identify a more
suitable code.
NOTE:
If no SMS is received on the mobile phone or if the message
ERROR / NO CODE
is displayed,
the system was not able to process the data;
do not attempt to send it again
and only use the
MANUAL SEARCH
to set the
code.
