Cableway
Installation, user and care guide
Part No: 134281 Issue No: 001
Contents
Cableway shown fully assembled for illustration purposes. Cableway is supplied without
fixings. Ensure to use fixings suitable for the intended furniture. Consult with your furniture
supplier if necessary.
Offer up the bottom
end of the connecting
blocks to the base plate
as shown.
Adjust the length of the
connecting blocks to
suit the desk height by
adding/removing blocks.
Use the top fixing
bracket to mark the
location of the fixing
holes.
Use a tape measure or
similar to align the base
plate with the top fixing
bracket.
Offer up the top end of
the connecting blocks to
the top fixing bracket as
shown.
Use 2x suitable screws
to secure the top fixing
bracket to the underside
of the desk.
Fully push the block
onto the base plate
until it clicks into place.
Check it is secure.
The Cableway is now
installed and ready to
accept cables.
Fix the base plate to the
floor with 2x suitable
screws if required.
Push the block into the
top fixing bracket until it
clicks into place. Check
it is secure.
Ensure the bracket
is secure but do not
overtighten.
Ensure the base plate
is secure in place but
do not overtighten the
fixings.
Installing the connecting blocks
Installing the top fixing bracket
Installing the base plate
Measure the distance between the top fixing bracket and the base plate. Note
the Cableway is suitable for a maximum desk height of 745mm.
‘CLICK’
‘CLICK’
Max desk height 745mm
x1
x1
x1
