OFF POWER ON
MIN TEMP 120
0
DRAIN
START
DISHMACHINES
PRIMER SWITCHES
GL-X FRONT VIEW
STEP
CHEMICAL PUMPS
THERMOSTAT
POWER
6
FILL/START
7
DRAIN
10
9
8
WASH
TEMPERATURE
DISPLAY
Push "DRAIN" switch to empty machine.
10
STEP
OFF POWER ON
DRAIN
FILL/START
FILL
Turn Power Switch to "ON" position.
OFF POWER ON
DRAIN
FILL/START
Press and hold down "SANI", "DETERGENT"and "RINSE"
switches to prime chemicals.This step must be repeated
each time chemical containers are changed.
9
STEP
6
STEP
LINE 1
LINE 2
GROUND
GL-X
Quick Setup
Instructions
WARNING
: Electrical and
plumbing connections need
to be made by a licensed
service person and comply
with all Federal, State and
Local Health, Electrical,
Plumbing and Safety
codes.
11-2016
Reconnect thermostat wire. Set temperature at
120°F - 140°F.
8
STEP
NOTE: To prevent Heating
Element damage, the GL-X
heater must be filled with
water before the heating
element is energized. For
this reason the Thermostat
has intentionally been
disconnected at the factory
and will require
re-connection.
Hold down "FILL" Switch for approximately 10 - 15 seconds to allow water to flow
into the dishwasher. Water should reach “FILL LINE” which is located inside at the
back of the wash tank. Close door, then press “START” switch.
NOTE:
The 4th cam of timer assembly has to be adjusted to maintain the same
water level during the cycle.
7
STEP
OFF POWER ON
DRAIN
FILL/START
FILL LINE
The Spirit of Excellence
an Ali Group Company
an Ali Group Company
8
