Getting Started
2.2.
Receiving and Installation
When you receive your new EST-66, complete the assembly by installing the scrap tray assembly
with its overflow chute, the two wrapper shields and the curtain rods, which are shipped inside the
machine. After the box has been removed from the machine, remove the left and right stainless
steel wrapper shields and bolt them in place with the nuts and bolts provided. The wrapper shield
with the extra curtain clamps mounts onto the dirty end of the machine. Next, mount the scrap
tray assembly and overflow chute into position (see section
2.2.5 Scrap Tray Assembly
).
All of the spray arms should be inserted and in place over the wash tank compartments.
There are a total of three curtains used in the EST-66; two are long- narrow, one is short- wide.
The two long-narrow curtains have shorter rods than the other two curtains. The short rods hold
the curtains at the entrance and exit of the machine.
The sketch below lists curtain positions 1 through 6.
EST-66
1
2
3
4
5
6
LONG-NARROW
CURTAIN
DISH FLOW
DISHMACHINE FRONT VIEW
SHORT-
WIDE
CURTAINS
LONG-NARROW
CURTAIN
MODEL EST-66 Service & Parts Manual Rev. 1 .01A
Page
4
