CMA Dishmachines CMA-66 L.T., Руководство по установке и эксплуатации

Страница: 15 / 27

Operation
3. Operation
3.1. Initial Setup
3.1.1. Auto Fill Timer/ Auto Re- Fill Timer
Both timers for the CMA-44 are set at the factory, but may need to be adjusted at
the time of installation depending on supply water pressure. When the power switch
is activated, the machine should fill until water begins to overflow into the scrap
tray, at which point it should be set to stop filling.
If necessary, adjust the timer block marked “Auto Fill Timer” to shut off when water
is observed flowing into the scrap tray. This will set the proper wash and pre-wash
tank water level.
After the Auto Fill Timer adjustment has been set the auto re-fill system must be set
to fill the wash tank if there is the a loss in water. If water level were to drop to the
level of the float switch located in the wash tank, the float switch will trigger the Auto
Re-Fill timer and begin refilling the wash tank. This auto re-fill system will assure
the water level stays at appropriate levels.
If necessary, adjust the Auto Re-Fill Timer by draining the wash tank manually
(open drain valve) until float activates Auto Re-Fill timer. When the auto re-fill is
activated, the machine should fill until water begins to overflow into the pre-wash
tank, at which point it should be set to stop filling.
Note: Auto Fill/Auto Re-Fill can be adjusted by turning potentiometer with a
small flat blade screwdriver. Since the range of this solid-state timer is from 6
seconds to 240 seconds, it is important to adjust timer in small increments.
Note: Every time power is interrupted and restored the Auto Fill Timer will reset
and add an additional full charge of water. It assumes the machine has been
drained, and is preparing for next wash cycle period.
3.1.2. Auto Fill Timer (Earlier Models with IDEC Timer Relay Socket)
When Auto Fill is activated, the machine should fill until it begins to overflow into the
scrap tray, at which point it should stop filling.
1. If necessary, adjust the time set on the Auto Fill Timer to allow an appropriate amount of
water flow to properly fill the Dishmachine. Plug the Timer Relay (P/N 13418.85) into the
Timer Relay Socket (P/N 13419.85) and check that it is set up as follows:
a. Mode selected is “D”
b. Scale displayed is “0 – 18”
c. Range selected is “10S”
d. Timer dial is set near 9 ½
MODEL CMA-66 Installation & Operation Manual Rev. 1.09B
Page 14