WASH TEMP 150
O
-160
O
FINAL RINSE TEMP 180
O
-195
O
POWER
OFF
DRAIN
START
CYCLE
ON
DISHMACHINES
Turn power supply back on. Allow machine to heat
up (about 5 minutes). Cycle machine by pushing
start switch. Observe “Rinse Cycle” (last 16 seconds
of cycle) must be minimum 180°F. If necessary adjust
the temperature by turning the adjustment stem on
thermostat clockwise to increase.
6
STEP
FILL
3-2018
180UC
Quick Setup
Instructions
WARNING
: Electrical and plumbing
connections need to be made by a
qualified service technician and
comply with all available Federal,
State and Local Health, Electrical,
Plumbing and Safety codes.
STEP
The Spirit of Excellence
an Ali Group Company
After filling dishwasher for the first time,
(CAUTION:
turn power supply off)
reconnect the factory
unplugged wire to booster high-limit switch located
behind front panel.
8
STEP
CMA PN: 10130.02
START
ELECTRICAL
BLOCK
5
THERMOSTAT
9
DRAIN
180UC FRONT VIEW
RINSE
TEMPERATURE
DISPLAY
POWER
SCRAP
DRAWER
WASH
TEMPERATURE
DISPLAY
RINSE
PRESSURE
GAUGE
BOOSTER
HIGH LIMIT
SWITCH
8
PRIMER
SWITCHES
10
10
STEP
FILL
Press and hold down primer
switches until product is discharging
into the dishmachine.
Turn on power, push Booster Fill Button to fill the Booster Tank on initial start up. Listen for final rinse until water
cascades over scrap trap.
BOOSTER FILL
BUTTON
7
6
Chemical dispenser electrical hookup is located
inside control box. Chemical dispenser is optional.
It is not sold with dishmachine.
5
STEP
RINSE
DETERGENT
NOTE: To prevent Heating
Element damage, the 180UC
heater must be filled with
water before the heating
element is energized. For
this reason the High Liimit
Switch has intentionally
been disconnected at the
factory and will require
re-connection.
8
Turn power switch off and on and the machine will
be filled to correct level in wash tank.
7
STEP
FILL
9
