Club Car XRT 950 2009, Руководство по техническому обслуживанию и ремонту

Страница: 33 / 256

BODY AND TRIM Front Body
4
FRONT COWL INSTALLATION
1. Front cowl installation is reverse of cowl removal.
2. Tighten fascia mounting frame bolts to 11 ft-lb (15 N·m).
3. Tighten front fascia bolts to 22 in-lb (2.5 N·m).
4. Tighten lower corner of the fascia torx-head screws to 22 in-lb (2.5 N·m).
INSTRUMENT PANEL REMOVAL
1. Remove cowl. See Front Cowl Removal on page 4-6.
2. Remove steering wheel. See Steering Wheel Removal on page 7-1.
3. Remove knobs from shifting levers.
4. Disconnect wiring harness from components mounted in instrument panel.
5. At engine, loosen choke cable clamp (Figure 4-14, Page 4-9) and disengage choke cable (Figure 4-15,
Page 4-9) .
979
Figure 4-14 Choke Cable Clamp – loosen
980
Figure 4-15 Choke Cable Disengage
6. Remove wire ties that secure the choke cable to the frame.
7. Loosen instrument panel by removing four screws that secure the top of the instrument panel to the top of the
instrument panel support frame
(Figure 4-16, Page 4-9) and removing the two bolts that secure the bottom of
the instrument to the frame (Figure 4-17, Page 4-9) .
1174
Figure 4-16 Instrument Panel Hardware – screws
1177
Figure 4-17 Instrument Panel Hardware – bolts
2009-2012 XRT 950 Maintenance and Service Manual Page 4-9