Pre-Operation and Daily Safety Checklist
2005 XRT 1500 Gasoline and Diesel Vehicle Owner’s Manual
Page 19
ý
WARNING
• Make sure seat hinges and latch are securely engaged before operating vehicle.
The driver-side bucket seat is adjustable and can be moved forward or backward to accommodate the driver.
To adjust seat, push lever located under the driver seat to the left (towards outside of the vehicle). Position
seat and return lever to its original position.
See following WARNING.
ý
WARNING
• Do not adjust driver-side seat while vehicle is in motion.
To adjust the passenger-side seat:
1. Remove the seat from the vehicle.
2. Remove the four bolts and washers from the bottom of the seat mounting plate.
3. Align the mounting plate holes with holes in the seat to achieve the desired seat position.
4. Install washers and bolts and tighten to 96 in-lb (10.8 N·m).
5. Install seat in the vehicle.
See preceding WARNING “Make sure seat hinges and latch...”.
PRE-OPERATION AND DAILY SAFETY CHECKLIST
Each Club Car vehicle has been thoroughly inspected and adjusted at the factory; however, upon receiving
your new vehicle(s), you should become familiar with its controls, indicators, and operation. Carefully inspect
each vehicle to ensure that it is in proper working condition before accepting delivery.
Use the following checklist as a guide to inspect the vehicle. This checklist should be used daily to ensure that
the vehicle is in proper working condition and in conjunction with the Periodic Service Schedule on page 30.
Any problems should be corrected by a Club Car dealer/distributor or a trained technician.
• General:
All the parts should be in place and properly installed. Be sure that all nuts, bolts, and screws
are tight. Check hose clamps for tight fit.
• Safety and information decals:
Check to ensure that all safety and information decals are in place.
• Roll-over Protective Structure (ROPS):
Check to ensure the ROPS is not damaged and all hardware
is secure.
See Roll-over Protective Structure (ROPS) and Safety Belts on page 17.
• Safety belts:
Visually inspect for cuts, fraying, and loose parts.
See Roll-over Protective Structure
(ROPS) and Safety Belts on page 17.
• Tires:
Check for proper tire pressure. Visually inspect tires for wear, damage, and proper inflation on a
See Vehicle Specifications on page 48.
• Battery:
Check electrolyte to ensure it is at the proper level
. Check battery posts.
Wires should be tight and free of corrosion and battery should be fully charged.
• Engine:
Check for proper engine oil and coolant levels (diesel vehicles) and leaks.
See Engine Oil on
page 35 and Engine Coolant – Diesel Vehicles on page 41.
Check air filter and replace if necessary.
• Fuel:
Check fuel level.
See Fueling Instructions on page 43.
Check fuel tank, lines, fuel cap, pump,
fuel filters, and carburetor (gasoline vehicles) for fuel leakage. Drain water from the fuel filter (diesel
vehicle).
See Draining Water from Fuel Filter on page 44.
• Exhaust system:
Check for leaks.
• Hydraulic brakes:
Check fluid level.
Содержание XRT 1500 2005
Страница 1: ...Owner s Manual 2005 XRT 1500 Vehicles Gasoline and Diesel ...
Страница 2: ......
Страница 59: ......