Club Car V-GLIDE, Дополнение к руководству по обслуживанию

Страница: 97 / 112

TRANSAXLE (TYPE K) Transaxle
2004 V-Glide 36-Volt Electric Vehicle Maintenance and Service Supplement Page 16b-7
16B
8. If a chain hoist was used to raise the vehicle, lift the vehicle high enough to permit easy access and clear-
ance for removal of the motor. If a floor jack was used to raise the vehicle, lower the transaxle enough
to permit easy access and clearance for removal of the motor.
9. Remove the three motor mounting bolts (Figure 16b-12, Page 16b-7), and the motor positioning bolt
(Figure 16b-13, Page 16b-8) mounting the motor to the transaxle. See following CAUTION.
∆
CAUTION
• Do not position fingers under motor when sliding motor off of the input shaft. Fingers may get
pinched when motor disengages.
10. Carefully remove the motor from the transaxle. Slide the motor away from the transaxle until the motor
spline becomes disengaged from the input shaft, then lift motor out. See preceding CAUTION.
11. If a floor jack was used, pull floor jack from beneath the transaxle and allow the springs to rest on the floor.
12. Remove the U-bolts attaching the transaxle to the leaf springs (Figure 16b-11, Page 16b-7).
13. Carefully lift each end of the transaxle off its positioning pin (on the leaf spring) and slide the transaxle
to the rear and out of the vehicle.
14. Drain the lubricant from the transaxle and remove the axle shafts. See Axle Shaft and Oil Seal Removal
on page 16b-1. See following NOTE.
NOTE: Recycle or dispose of used oil or lubricant in accordance with local, state, and federal regulations.
15. Remove the brake assemblies if required. See Section 6 – Wheel Brake Assemblies in the appropri-
ate maintenance and service manual.
Figure 16b-11 Leaf Springs Figure 16b-12 Motor Mounting Bolts
DIFFERENTIAL
GEAR CASE
MOTOR MOUNTING
BOLTS
INTERMEDIATE
GEAR ASSEMBLY
INPUT
PINION
GEAR