Club Car V-GLIDE, Дополнение к руководству по обслуживанию

Страница: 73 / 112

MOTOR Reconditioning the Motor
2004 V-Glide 36-Volt Electric Vehicle Maintenance and Service Supplement Page 15-9
15
BEARING REMOVAL
1. Place the wedge attachment tool (CCI P/N 1012812) between the bearing (15) and the armature (17)
(Figure 15-10, Page 15-8). Make sure the wedge attachment tool is supporting the inner race of the
bearing. If a press is not available, secure a bearing puller (CCI P/N 1012811) to the bearing and pull the
bearing off the end of the armature shaft. Support the shaft so it will not drop when the bearing is
removed (Figure 15-11, Page 15-9). Discard the bearing.
BEARING INSTALLATION
1. Press a new bearing (15) onto the armature (Figure 15-10, Page 15-8). Use an arbor press that exerts
pressure on the inner race only. See following NOTE.
NOTE: Make sure the bearing retainer (16) is positioned on the armature shaft before the bearing is
pressed onto the armature (Figure 15-10, Page 15-8).
An arbor with an outside diameter of less than 5/8 inch (16 mm) should be used to press the bear-
ing onto the armature.
RECONDITIONING THE MOTOR
See General Warning, Section 10, Page 10-1.
Motor reconditioning must be performed by a qualified motor repair technician. The use of proper tools and
procedures is absolutely essential for successful motor reconditioning.
Figure 15-11 Bearing Removal
PRESS
RAM
WEDGE ATTACHMENT TOOL
(CCI P/N 1012812)
BEARING PULLER
(CCI P/N 1012811)