Club Car V-GLIDE, Дополнение к руководству по обслуживанию

Страница: 24 / 112

ELECTRICAL SYSTEM AND TESTING Test Procedures
Page 11-12 2004 V-Glide 36-Volt Electric Vehicle Maintenance and Service Supplement
11
Test Procedure 7 – Resistors, Continued:
1. Inspect the resistors for loose connections, damaged coils or wiring, or problems of any kind.
2. If there are no problems, place the red (+) probe of the multimeter (set to 200
Ω
) on the first resistor con-
nection, and place the black (–) probe on the last resistor connection. The reading should be continuity
or approximately 0.9
Ω
(ohms) (Figure 11-10, Page 11-11).
3. If the reading is incorrect, check the resistors again for loose connections or damage. Replace any dam-
aged parts.
TEST PROCEDURE 8 – FORWARD/REVERSE SWITCH
See General Warning, Section 10, Page 10-1.
1. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 10, Page 10-1.
2. Use a multimeter set to 200
Ω
to test the Forward/Reverse switch in both directions.
2.1. With the Forward/Reverse switch in the FORWARD position, place the red (+) probe on the com-
mon terminal lug of the switch (with brown wire attached), and place the black (–) probe on the mov-
able contact (with the purple wire attached) on the forward and reverse rotor (Figure 11-11,
Page 11-12). The reading should be continuity.
2.2. With the Forward/Reverse switch in the FORWARD position, place the red (+) probe on the forward
terminal lug (with the 6-gauge red wire attached) of the Forward/Reverse switch, and place the
black (–) probe on the movable contact (with the white wire attached) on the forward and reverse
rotor (Figure 11-12, Page 11-12). The reading should be continuity.
2.3. With the Forward/Reverse switch in the REVERSE position, place the red (+) probe on the common
terminal lug (with brown wire attached) of the Forward/Reverse switch, and place the black (–)
probe on the movable contact (with the white wire attached) on the forward and reverse rotor
(Figure 11-13, Page 11-13). The reading should be continuity.
Figure 11-11 Forward/Reverse Switch Test – Step 2.1 Figure 11-12 Forward/Reverse Switch Test – Step 2.2
- +
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
Ω
Ω
1000
OFF
WAVETEK 5XL
V
V
V
A
! ! COM 200nA
MAX
1000 ---
750V
FUSED
- +
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
Ω
Ω
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM
200nA
MAX
1000 ---
750V
FUSED