Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту

Страница: 292 / 414

19
Starter/Generator
GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
– Use combination of above methods.
3. Mark a location on belt to repeat tension measurement each time. Use paint pen or permanent marker of
light color.
4. For Existing Belts Only: Verify current belt tension using Universal Belt Tension Gauge (OTC
®
6673
recommended) (Figure 19-15, Page 19-13) . Proper tension for a used starter/generator belt is 75 to 85 lbf
(334 to 378 N).
– If belt tension is within accepted range, no further action is needed. Connect battery and spark plug wire(s).
See Connecting the Battery- Gasoline Vehicles on page 1-3.
– If belt tension is not within accepted range, continue procedure. See following NOTE.
NOTE: To expedite procedure for existing belt and avoid need for a pry bar, first install belt tension tool and then
loosen starter/generator mounting hardware.
5. Tighten starter/generator mounting hardware (4 and 7) finger-tight (Figure 19-13, Page 19-12) .
6. Install belt tension tool.
6.1. Carefully insert pry bar between starter/generator and bracket.
6.2. Carefully lift starter up until tension tool can be installed as shown over the slotted adjustment bracket
(Figure 19-16, Page 19-13) . Note orientation of tension tool on the slotted adjustment bracket and how the
threaded J-bolt is inserted into the slot under the starter/generator mounting ear.
NOTE: In some cases, the threaded J-bolt of the belt tension tool does not have enough length to consistently fit
under the starter/generator mounting ear. Fit can be greatly improved by modifying the tension tool using
the following procedure.
– Remove nut and J-bolt from bracket.
– Grind or cut 3/8 to 1/2 inch (9.5 to 12.7 mm) from bracket as shown to increase the effective length of
the J-bolt (Figure 19-17, Page 19-14) .
– Install J-bolt and nut into bracket.
6.3. Remove pry bar.
A
1 2
A. Remove 3/8 to 1/2 inch (9.5 to 12.7 mm)
1. Before 2. After
2726
Figure 19-17 Belt Tension Tool Modification (If Necessary)
7. Tension belt.
Page 19-14 2019 Precedent Villager 2 Maintenance and Service Manual