5
Pedal Group – Gasoline Vehicle
ACCELERATOR AND BRAKE PEDAL GROUP
PEDAL GROUP – GASOLINE VEHICLE
See General Warnings on page 1-2.
PEDAL GROUP REMOVAL
1.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery – Gasoline Vehicles on page 1-3.
2.
Remove screws (1). Pull floor mat retainer (3) away from the vehicle
.
3.
Pull floor mat (2) over the pedal group to gain access to the pedal group hardware.
4.
Remove fastener (10) and lift off cover plate (7)
5.
Loosen jam nuts (4 and 5) on each side of turnbuckle (6).
NOTE:
Nut (4) has a left-hand thread.
6.
Loosen turnbuckle (6) until the threaded rod (8) from the pedal group (11) is free of the turnbuckle
1
2
3
629
Figure 5-3
Pedal Group Access
7.
Loosen two nuts (9) on the accelerator cable and lift the cable from its mounting bracket.
8.
Remove two screws (2) on the driver side of the pedal group and two screws (1) on the passenger side of
the pedal group.
9.
Disconnect six-pin connector (12) from throttle position sensor.
10. Release the end of the accelerator cable (13) from the pedal group.
11. Lift pedal group from vehicle.
Page 5-4
2014 Precedent
®
Golf Car Maintenance and Service Manual
Содержание Precedent 2014
