Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 39 / 344

ACCELERATOR AND BRAKE PEDAL GROUP Accelerator Pedal
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 5-5
5
3. Install the bushings (30) in the park brake pedal and position the park brake pedal on the shaft on the
brake pedal assembly weldment (10) (Figure 5-4, Page 5-4). Then attach the ends of the torsion spring
to the park brake pedal and to the brake pedal weldment as shown (Figure 5-5, Page 5-5).
4. Install the push nut (32) on the park brake pedal shaft (Figure 5-4, Page 5-4).
5. Connect park brake rod (17) with ball joint (21) to the ball stud on the park brake pedal assembly (Fig-
ure 5-4, Page 5-4).
ACCELERATOR PEDAL
ACCELERATOR PEDAL REMOVAL
1. Make sure key switch is OFF and that the Forward/Reverse Switch is in NEUTRAL, then disconnect
battery. See following WARNING.
∆ WARNING
• Disconnect both battery cables, negative cable (–) first.
2. Place chocks under the rear wheels.
3. Disconnect the accelerator rod assembly (17, 18, and 19) (Figure 5-18, Page 5-12) at the front and
rear ball studs and remove it from the vehicle.
4. Using a 9/16" socket and 9/16" wrench, remove the nut (20), two washers (5), and bolt (4) securing the
accelerator pedal (1) to the pivot rod (6) (Figure 5-18, Page 5-12).
5. Remove the nut (10), ball stud (8), and pivot support bearing (9) from the accelerator pivot rod assem-
bly (6) (Figure 5-18, Page 5-12).
6. Slide the spring retainer (11) off of the accelerator pivot rod.
Figure 5-5 Attach Torsion Spring
LIFT OTHER END OF SPRING (20) UP AND
OVER BRAKE WELDMENT BY PRYING DOWN
ON SHAFT WITH SMALL SCREWDRIVER
SHAFT
20
HOOK ONE
END OF
SPRING (20)
ON PARK
BRAKE
WELDMENT