Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 34 / 344

BODY AND TRIM Tailskirt
Page 4-12 2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual
4
Receiver Hitch Removal, Continued:
3. Where the hitch (7) is mounted to hitch brace (8), remove the nut (12), lock washer (11), washer (10)
and bolts (9) (Figure 4-6, Page 4-11).
4. Remove hitch (7) from vehicle.
RECEIVER HITCH INSTALLATION
1. Reverse removal procedures to install hitch (7) (Figure 4-6, Page 4-11). Tighten hardware to 15 ft-lb
(20.3 N·m).
TAILSKIRT
Read WARNING and CAUTION on page 4-1.
TAILSKIRT REMOVAL
1. Remove two thread-forming screws (5) from tailskirt (4) and lift tailskirt from vehicle frame (Figure 4-6,
Page 4-11).
TAILSKIRT INSTALLATION
1. Insert upper edge of tailskirt (4) under, and in front of, back edge of rear body (Figure 4-6, Page 4-11).
2. Align holes in tailskirt (4) with holes in vehicle frame. Position tailskirt flush against frame (Figure 4-6,
Page 4-11).
3. Install two thread-forming screws (5) in tailskirt and tighten to 55 in-lb (6.2 N·m) (Figure 4-6, Page 4-11).
FLOOR MAT
Read WARNING and CAUTION on page 4-1.
FLOOR MAT REMOVAL
1. Remove the brake and accelerator pedals. See Section 5 – Accelerator and Brake Pedal Group.
2. Remove the top edge of the floor mat from the overlapping flange under the dash.
3. Lift the mat from the vehicle.
FLOOR MAT INSTALLATION
1. Install the floor mat in the reverse order of removal.
2. Install the brake and accelerator pedals. See Section 5 – Accelerator and Brake Pedal Group.