Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 327 / 344

TORQUE CONVERTER Drive Clutch
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 17-11
17
13.1. Install spring on right side of any one of the three button mounting posts (when looking into the
interior of the clutch cover with the rib at the twelve o’clock position) as shown (Figure 17-15,
Page 17-11).
14. While compressing the take-up spring, install the drive button over the rib and take-up spring as shown
(Figure 17-8, Page 17-8).
15. Install remaining two buttons.
16. Install a number 10-24 button retaining screw with flat washer through each button and into the rib.
Tighten the screws to 34 in-lb (3.8 N·m) (Figure 17-9, Page 17-8).
Figure 17-14 Install White Washers
Figure 17-15 Correct Orientation of Drive Button Take-up Spring
Pin should protrude an equal amount
on each side.
Install white
washers on
each side
of pin.
DRIVE BUTTON TAKE UP
SPRING PROPERLY INSTALLED