Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 224 / 344

FE350 ENGINE Crankshaft and Counterbalance
Page 13-36 2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual
13
Crankshaft and Counterbalance Disassembly
1. Slide the spacer (2) and the link rod (3) off the flywheel end of the crankshaft. Remove the counterbalance
from the remaining link rod (Figure 13-74, Page 13-35). Go to Link Rod Inspection on page 13-37.
2. If the link rods need replacing, place the gear yoke (CCI 1016418) under the spur gear with the small
end of the connecting rod located opposite the crankpin (Figure 13-75, Page 13-36).
3. Position the gear yoke with the side blocks positioned as close to the crankshaft as possible (Figure
13-75, Page 13-36).
4. Using a press, push on the end of the crankshaft to pull the spur gear and the helical gear off the crank-
shaft (Figure 13-76, Page 13-36). See following WARNING and CAUTION.
∆ WARNING
• Support the crankshaft while pressing. This will prevent the crankshaft from dropping to the
floor after the gear has been removed.
∆ CAUTION
• Use a press when removing the spur gear and helical gear from, or installing them on the crankshaft.
5. Remove the woodruff key.
6. Slide the remaining link rod off the crankshaft.
Figure 13-75 Place Assembly in Press Figure 13-76 Remove Helical and Spur Gears
HELICAL GEAR
GEAR YOKE
CCI 1016418
SPUR GEAR
SIDE
BLOCKS (2)
PRESS
TABLE
PRESS RAM
WARNING
PRESS
TABLE
GEAR YOKE
SIDE BLOCKS