Club Car Pioneer 900, Руководство по техническому обслуживанию

Страница: 197 / 344

FE350 ENGINE Cylinder Head
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 13-9
13
∆ WARNING
• Plug fuel line to prevent gas from draining from line.
5. Remove cotter pin (3) and clevis pin (2) from throttle lever.
6. Remove nuts at carburetor intake pipe (5) and remove intake pipe. See following CAUTION.
∆ CAUTION
• Disconnect the governor linkage from the carburetor before attempting to remove the carburetor.
Failure to do so could damage the linkage.
7. Remove carburetor (4) along with throttle spring (8) and throttle spring bracket (23) (Figure 13-6,
Page 13-9).
8. Remove muffler. See Section 15 – Exhaust System.
9. If the engine is to be totally disassembled, drain oil and remove the oil filter. If only the cylinder head is
to be disassembled, proceed without draining the oil or removing the oil filter.
10. Disconnect oil filler tube (20) from cylinder shroud by first removing the locknut (18), ground wire (17)
and flange nut (10) and then pulling oil filler tube out of the crankcase cover (Figure 13-8, Page 13-10).
NOTE: Make sure vehicle is level before removing filler tube. This will prevent oil from spilling when filler tube
is removed.
11. Remove the nine bolts (14) and two-ended bolt (11) (Figures 13-8 and 13-9, Page 13-10).
12. Take off the head shroud (13), the upper shroud (23) and the bracket (22).
Figure 13-6 Carburetor Removal Figure 13-7 Carburetor, Fuel Line and Vent Line
6
7
8
5
4
3
2
23
4
9
10